This is an archive version of the document. To get the most up-to-date information, see the current version.

Replica Failover

Failover is a process of switching from the original VM on the source host to its VM replica on the target host.

During failover, Veeam Backup & Replication recovers a fully functional VM to the required restore point on the target host. As a result, you have a VM up and running within a couple of seconds, and your users can access services and applications they need with minimum disruption.

When you perform failover, the state of the original VM on the source host is not affected in any way. If you need to test the VM replica and its restore points for recoverability, you can perform failover while the original VM is running. After all necessary tests, you can undo failover and get back to the normal mode of operation.

Replica Failover Note:

If the original VM and VM replica are located in the same network and you plan to perform replica failover while the original VM is running, consider temporary disconnecting the original VM from the network to avoid IP addresses and/or machine names conflicts.

It is recommended that you always use Veeam Backup & Replication to perform failover operations. Avoid powering on a replica manually — this may disrupt further replication operations or cause loss of important data.

Veeam Backup & Replication performs the failover process for snapshot VM replicas and legacy VM replicas in different ways.

Snapshot VM Replicas

The failover operation for snapshot VM replicas is performed in the following way:

Veeam Backup & Replication rolls back the VM replica to the required restore point. To do this, Veeam Backup & Replication applies the necessary snapshot from the replica chain to the VM replica.
Veeam Backup & Replication powers on the VM replica. The state of the VM replica is changed from Ready to Failover. If you perform failover for testing or DR simulation purposes, and the original VM still exists and is running, the original VM remains powered on.

Note that any replication activities for the original VM will fail until the VM replica is returned to the Ready state.

All changes made to the VM replica while it is running in the Failover state are written to the differencing disk (AVHD/AVHDX) of the snapshot, or restore point, to which you have selected to roll back.

Replica Failover

Legacy VM Replicas

The failover operation for legacy VM replicas is performed in the following way:

To protect the VM replica from altering, Veeam Backup & Replication takes a protective snapshot for the VM replica.
Veeam Backup & Replication rolls back the VM replica to the required restore point.
Veeam Backup & Replication powers on the VM replica. The state of the VM replica is changed from Ready to Failover.

Note that any replication activities for the original VM will fail until the VM replica is returned to the Ready state.

All changes made to the VM replica while it is running in the Failover state are written to the differencing disk of the created protective snapshot.

In Veeam Backup & Replication, the actual failover is considered a temporary stage that should be further finalized. While the replica is in the Failover state, you can undo failover, perform failback or perform permanent failover. In a disaster recovery scenario, after you test the VM replica and make sure the VM runs stable, you should take another step to perform permanent failover.