Veeam Home | Support | Downloads
Veeam Endpoint Backup FREE 1.1

Veeam Endpoint Backup FREE Help Center  > User Guide >  Overview > Data Backup > Backup to Rotated Drives

Backup to Rotated Drives

Previous page Next page Print this Topic

Table of contents

You can use rotated drives as a target location for backups. This scenario can be helpful if you want to store backups on several external hard drives (for example, USB or FireWire) and plan to swap these drives between different locations regularly.

Backup on rotated drives is performed in the following way:

1.Veeam Endpoint Backup creates a backup chain on an external drive that you use as a backup target. The backup chain consists of the first full backup and a set of subsequent incremental backups.
2.When you swap drives and attach a new external drive, Veeam Endpoint Backup creates a separate backup chain on the new drive.
3.After you swap drives again, Veeam Endpoint Backup detects if there is a backup chain on the currently attached drive. If the backup chain exists, Veeam Endpoint Backup continues the existing chain: it creates a new incremental backup file and adds it to the existing backup files.

To use rotated drives for backup, you must perform the following actions:

1.Attach one of external drives from the set to your computer.
2.Configure the backup job to store backups on the currently connected external drive. To do this:
a.At the Local Drive step of the wizard, select the connected drive.
b.From the Local drives list, select the necessary volume on the connected drive and specify a folder where backups must be stored.
c.Save the job settings.

3.When you need to swap files, disconnect the drive that was used previously and attach a new drive to your computer.
4.Register a newly connected drive as a known removable storage in Veeam Endpoint Backup. To do this:
a.Double-click the Veeam Endpoint Backup icon in the system tray to open the Control Panel.
b.Click the Settings tab, then click the Manage registered storage devices link.
c.Click Register next to the newly connected drive.

If you do not register the newly connected drive before the backup job starts, Veeam Endpoint Backup will be unable to detect the backup target and launch the backup job. Veeam Endpoint Backup will display a warning in the system tray and in the Control Panel. To register a new device, click the Add removable storage device link in the Status view of the Control Panel and register the newly connected drive as described above.

To learn more, see Managing Rotated Drives.

5.After you register the newly connected drive, you can start a new backup session manually or wait Veeam Endpoint Backup to start a new session.

Table of contents