步骤8.重新配置IP规则

在本页面

The Re-IP step is available if you have selected the Replica re-IP check box at the Name step of the wizard. This step applies only to VMs with Microsoft Windows OSes.

At the Re-IP step of the wizard, configure re-IP rules. These rules map IPs in the production site to IPs in the disaster recovery (DR) site. When you perform failover, Veeam Backup & Replication will check the configured re-IP rules and will change replica IPs if the rules apply. VM replicas will get new IP addresses according to the network masks specified in the rules, so that you will be able to reach replicas in the DR site.

To configure a re-IP rule:

Click Add.
In the Source VM section, specify an IP numbering scheme used in the production site.

To facilitate the configuration, Veeam Backup & Replication detects an IP address and subnet mask for the backup server and pre-populates values in the Source VM section.

In the Target VM section, specify an IP address, subnet mask and default gateway that will be used for replicas in the DR site. If required, specify the DNS and WINS server addresses.
In the Description field, provide a description the rule.
Click OK.

Note

Mind the following:

Do not use 0 to specify IP address ranges. In Veeam Backup & Replication, value 172.16.17.0 means a regular IP address 172.16.17.0, not an IP address range. To specify a range, use the asterisk character (*).

Replica re-IP works only if you perform replica failover using Veeam Backup & Replication. If you power on a VM replica in some other way, for example, manually using vSphere Client, re-IP rules will not be applied to it.
The backup server OS must support mounting of the system disks of VMs that will be replicated.

Step 8. Configure Re-IP Rules