Help Center
Choose product document...
Veeam Backup & Replication 9.5
User Guide for Microsoft Hyper-V

Network Mapping and Re-IP

If you use different network and IP schemes in production and DR sites, in the common case you would need to change the network configuration of a VM replica before you fail over to it. To eliminate the need for manual replica reconfiguration and ensure minimum failover downtime, Veeam Backup & Replication offers possibilities of network mapping and automatic IP address transformation.

Network Mapping

By default, a replicated VM uses the same network configuration as the original VM. If the network in the DR site does not match the production network, you can create a network mapping table for the replication job. The table maps source networks to target networks.

During every job run, Veeam Backup & Replication checks the network configuration of the original VM against the mapping table. If the original VM network matches a source network in the table, Veeam Backup & Replication updates the replica configuration file to replace the source network with the target one. The VM replica is then re-registered (for legacy VM replicas, not snapshot VM replicas). Thus, network settings of a VM replica are always kept up to date with the DR site requirements. In case you choose to fail over to the VM replica, it will be connected to the correct network.

Network Mapping and Re-IP Note:

If you use VLAN IDs for networking, you can specify VLAN IDs settings for source and target networks.

Re-IP Rules

For Microsoft VMs, Veeam Backup & Replication also automates reconfiguration of VM IP addresses. If the IP addressing scheme in the production site differs from the DR site scheme, you can create a number of Re‑IP rules for the replication job.

When you fail over to the replica, Veeam Backup & Replication checks if any of the specified Re-IP rules apply to the replica. If a rule applies, Veeam Backup & Replication mounts VM disks of the replica to the backup server and changes its IP address configuration via the Microsoft Windows registry. The whole operation takes less than a second. If failover is undone for any reason or if you fail back to the original location, replica IP address is changed back to the pre-failover state.

Network Mapping and Re-IP Important!

Replica re-IP works only if you perform replica failover using Veeam Backup & Replication. If you power on a VM replica in some other way, for example, manually using Hyper-V Manager, re-IP rules will not be applied to it.

Veeam Large Logo

User Guide for VMware vSphere

User Guide for Microsoft Hyper-V

Enterprise Manager User Guide

Veeam Cloud Connect Guide

Veeam Backup Explorers User Guide

PowerShell Reference

RESTful API Reference

Veeam Backup FREE Edition User Guide

Veeam Backup for Microsoft Office 365

Veeam ONE Documentation

Veeam Endpoint Backup Documentation

Veeam Management Pack Documentation